To work on a cloth in order to prevent that a transfer is stuck on the table and to use a bowl filled with hot water, cotton buds and paper towel.

To cut out with the scissors of the small zones of transfers and to soak them in water 10 seconds approximately then to drain the surplus of water, to still wait a few seconds that the transfers fall apart of paper.

To apply transfers it by making it slip of its support using a cotton bud and drive out the bubbles of air in order to make him marry the surface of the car as well as possible, to soak the surplus of water with paper towel.

For the delicate forms, to soften transfers it, you can apply a product envisaged for this purpose or a little alcohol spirits with another cotton bud by paying attention to not too in to put.(Caution, certain paintings support alcohol spirits badly, to carry out a test as a preliminary).

It is possible to varnish a model once the transfers posed and dried well, according to varnish's used, to carry out a preliminary test.

You can create your transfers with your laser printer or jet of ink, using special sheets (white or transparent zone according to reasons), without forgetting to apply a varnish plasticizing after the impression.
Caution : cut out your transfers one by before plunging them in water and applying them, because they all are dependent whole by varnish.

Go to the page Décals

If you have suggestions, do not hesitate with us to make share of it.